Investigating the pathway and fate of inorganic impurities in a bisulfite dissolving pulp production process
Abstract
This study sought to investigate the pathway and fate of metals and Si in a bisulfite pulp \nproduction process, at the same time providing a means to mitigate on the residual metals \nbound in the final pulp. The metals pathway and fate was traced from the Eucalyptus \nplantation, through the pulp production process. Principal component analysis was employed \nto determine the correlation between the observations and the variable of interest. It was \nestablished that Fe is a limiting factor in the growth of the Eucalyptus trees in the forest under \nstudy. The main pathway for the metals and silicon was found to be the exchangeable soil \nfraction. The residual metals in the pulp material during pulping and bleaching process are \ninfluenced by the media pH, the accessibility of the active sites, the affinity of the metal \ntowards the active sites and the degree of delignification and hemicelluloses extraction. Metal \ndesorption under the influence of acetylacetone at both pH 6 and 8 were best described by \nLangmuir desorption model. Pulp metal desorption under the influence of EDTA was also \nbest described by the Langmuir model except for Al (R2) 0.572 and 0.004, at pH 6 and 8 \nrespectively. This implies that most of the metals in the dissolving pulp sample were \nchemically adsorbed on the surface of the pulp. However, aluminum was poorly described by \nthe Langmuir isotherm model. This is because polyvalent metals like Al are hard Lewis acids, \ncapable of strong and specific bonding to hard Lewis base functional groups on organic \nmolecules. The Freundlich model described Mg, Al and Cu desorption suggesting some \nfraction of these metals to have been physically adsorbed onto the pulp material. It is possible \nthat the metal fraction being physically desorbed was introduced onto the pulp during the \npulp bleaching process. Voltammetry was employed to investigate the effect of organic \nligands on metal mobility in bleaching filtrates. It was observed that filtrate samples obtained \nfrom the alkaline-oxygen bleaching stage produced higher current peak suppression at pH 2 \nas compared to the filtrate samples obtained from alkaline bleaching stage; this indicates the \npresence of stronger none-labile metal ligands. At a higher pH of 3.6 the voltammograms of \nthe filtrates obtained from the alkaline-oxygen delignification produced higher cathodic peak \nshifts. The extent to which the peak potential shifts cathodically is indicative of the \nmagnitude of the stability constant. This may imply that the samples obtained from the \nalkaline-oxygen delignification comprise of ligands that form strong metal-ligand complexes
Identifiers
Citation
Kamau, J. N. (2011). Investigating the pathway and fate of inorganic impurities in a bisulfite dissolving pulp production process. [Dissertation]. ResearchSpace (University of KwaZulu-Natal). http://hdl.handle.net/10413/12396
Collections
Endorsement
Review
Supplemented By
Referenced By
Usage Stats
0views

